Limited Warranty

Fine Art Lamps warrants to the original purchaser that its lighting products will be free from defects in material and workmanship under normal use and service, subject to the limitations described below. Lighting products in which such defects do occur will be repaired or replaced at Fine Art Lamps’ option. This remedy is the original purchaser’s exclusive remedy and Fine Art Lamps does not authorize any person to create for it any other obligation or liability in connection with Fine Art Lamps’ lighting products. Lighting products are made of naturally variable raw materials. With regard to outdoor lighting products, such products will weather over time, adding to their character and modifying their appearance. Differences in grain, character and color, and product weathering are naturally occurring variations and not within the control of the Fine Art Lamps nor considered defects under this limited warranty. Consult the individual item warranty for item-specific warranty details, such as the warranty period. Fine Art Lamps’ customer is the Dealer. All complaints must be resolved through the Dealer from which the lighting product was purchased. To obtain warranty service, the Dealer must supply dated proof of purchase. This limited warranty gives the original purchaser specific legal rights and the original purchaser may also have other rights, which vary from state to state. THIS LIMITED WARRANTY AND THE INDIVIDUAL ITEM WARRANTY ARE THE ONLY WARRANTIES PROVIDED BY FINE ART LAMPS REGARDING ITS LIGHTING PRODUCTS. TO THE MAXIMUM EXTENT PERMITTED BY LAW, FINE ART LAMPS EXPRESSLY DISCLAIMS, AND YOU HEREBY WAIVE, ALL OTHER WARRANTIES OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING, WITHOUT LIMITATION, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE THAT MAY BE APPLICABLE TO FINE ART LAMPS’ LIGHTING PRODUCTS IS LIMITED BASED ON THE INDIVIDUAL ITEM WARRANTY. FINE ART LAMPS SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES OR FOR ANY CLAIMS, DAMAGES, EXPENSES OR LOSSES, EVEN IF FINE ART LAMPS HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. NOTWITHSTANDING THE FOREGOING WARRANTIES, IN NO EVENT WILL FINE ART LAMPS BE LIABLE FOR ANY CLAIMS, DAMAGES, EXPENSES OR LOSSES ARISING OUT OF OR RELATED TO ANY CAUSES BEYOND FINE ART LAMPS’ CONTROL, INCLUDING, WITHOUT LIMITATION, DAMAGES DUE TO LIGHTING PRODUCTS THAT HAVE BEEN MISUSED, ALTERED, IMPROPERLY INSTALLED, ABUSED (INCLUDING SHIPPING), NEGLECTED, IMPROPERLY MAINTAINED, OR SUBJECTED TO POWER SURGES OR INCLEMENT CONDITIONS. THESE LIMITATIONS OF LIABILITY SHALL SURVIVE THE FAILURE OF ANY EXCLUSIVE REMEDIES. SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF IMPLIED WARRANTIES OR LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, THEREFORE CERTAIN OF THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.

 

Cleaning & Maintenance

Outdoor Product

  • Make sure the switch is turned off.
  • If needed, secure a ladder near light fixtures you cannot reach from ground.
  • Remove any globes, shields or grills with an appropriate tool (most likely a screwdriver);,then unscrew and remove the light bulbs (or fluorescent tube). Set all parts aside.
  • Fill two large buckets with hot water and add dish soap. Agitate the water to create suds.
  • Place removed items (not the light bulbs) in one bucket.
  • Saturate a rag or sponge with sudsy water from the second bucket, and use that to wipe down the parts,of the light fixture that you could not remove. Keep water from running into open sockets.
  • Rinse the fixed pieces with water; remove the loosened pieces from their bucket, wipe them down and,rinse them as well.
  • When all pieces are dry, apply polish or wax to metal parts if desired; use glass cleaner to clean,glass globes or shades.
  • Wipe off light bulbs or tubes with a damp rag (or replace them if burned out), being careful not to get,the end that screws into the socket wet; then reassemble the light fixtures.

For oceanfront enviorments we recommend that all luminaires be cleaned in the Spring, or at 6 month intervals, in order to remove the salt and dust that accumulated during the winter season.

  • Rinse fixture with tap water, ensuring any accumulated salt buildup is removed. Adjust water pressure accordingly.
  • Wash the surfaces with a medium brush and light soap with PH not higher than 8.5.
  • Rinse again with tap water, adjusting water pressure accordingly.

Indoor Product

Due to the nature of our exquisite hand applied finishes, our product requires special cleaning. Use of water or other liquid cleaning products may result in stains or damage to the finish of the lamp.   We recommend the use of only a dry, lint-free cloth to remove dust on all surfaces of our product including glass, mirror & crystals.